Free Flyball Jump Plans
Shown in Inches

To make sure all the uprights are uniform, you can make a cardboard tracer with the appropriate dimensions.

< Two different upright profiles shown >

Tools needed: Table saw or a Skill saw, Jig Saw, Drill, Drill bits, Sander or sand paper.When purchasing the plywood from the lumber store, ask them to make two (2) - 32" cuts for you on ther cross cut saw (if they have one).

You want three 32"x48" peices of plywood. This makes it easier to transport and to work with.To make sure all the uprights are uniform, make a card board tracer with the appropriate dimensions.Sand and paint.

The 6" base boards and slats must be painted white as per NAFA regulations. Exterior oil base paint is recommended.

If jump heights higher than 12" are needed you will need to cut out another
4-4" or 8-2" slats from an extra piece of 1/2" plywood.

Please note: Sintra slats are recommended for the tops of the jumps to help avoid injury to the dog.
To find out more about Sintra Slats Sintra slats as well.